Monoprice 1m 28AWG External SAS 34pin (SFF-8470) Male W/ Thumbscrews To SAS 34pin (SFF-8470) Male W/ Thumbscrews Cable - Black

Impedance Correction Chart SpeakerImpedance AmplifierRating Jumper Setting /# of Speaker Pairs x1 x2 x4 x8 4‑ohm Speakers 2 ohms 2 pairs 4 pairs 8 pairs 16 pairs 4 ohms 1 pair 2 pairs 4 pairs 8 pairs 8 ohms This is done by setting the jumpers on the volume control to compensate for the number of speakers you have in a parallel configuration and the impedance level of the speakers.. This specially designed unit comes in a weatherproof, sealed enclosure specifically designed for outdoor installations.

So two 4‑ohm speakers wired in series is the same impedance as a single 8‑ohm speaker. Wouldn't it be easier to have a volume controller out in your patio? The water resistant enclosure also makes it perfect for marine (boating) applications. Here's your solution: an outdoor speaker volume controller.

  It supports a frequency range of 20Hz to 20kHz.

Spread Your Music Everywhere. It supports a frequency range of 20Hz ~ 20kHz. This device can handle up to 100 watts per channel. Monoprice™ brings everything within reach of the average homeowner by offering a wide selection of Home Audio Distribution accessories.

For more information, go to www.

ca. Monoprice 6-Channel Speaker Selector. Built‑in impedance‑matching circuitry ensures that the overall impedance level to the amplifier does not drop below 5 Ohms, no matter how many speaker zones are selected or how many speakers are in each zone. The unit can handle up to 70 watts per channel with the protection circuitry enabled and up to 140 watts per channel with the protection circuit disabled.

Guide to SAS ConnectorsType# of PinsEnvironmentSFF-808736InternalSFF-808826ExternalSFF-848229InternalSFF-848432InternalSFF-847034External (also sometimes internal) This allows the user to mix more expensive, lower-capacity SAS drives for applications that require faster data access and higher reliability, with lower-cost, higher-capacity SATA drives for applications with lower access speed requirements.

Guide to SAS ConnectorsType# of PinsEnvironmentSFF-808736InternalSFF-808826ExternalSFF-848229InternalSFF-848432InternalSFF-847034External (also sometimes internal) This allows the user to mix more expensive, lower-capacity SAS drives for applications that require faster data access and higher reliability, with lower-cost, higher-capacity SATA drives for applications with lower access speed requirements.

Monoprice 1m 28AWG External SAS 34pin (SFF-8470) Male w/ Thumbscrews to SAS 34pin (SFF-8470) Male w/ Thumbscrews Cable - Black It has a 34-pin SFF-8470 male SAS plug (with locking thumbscrews) on each end..Guide to SAS ConnectorsType# of PinsEnvironmentSFF-808736InternalSFF-808826ExternalSFF-848229InternalSFF-848432InternalSFF-847034External (also sometimes internal) This allows the user to mix more expensive, lower-capacity SAS drives for applications that require faster data access and higher reliability, with lower-cost, higher-capacity SATA drives for applications with lower access speed requirements.Intended primarily for data storage centers, the SAS interface is backwards compatible with SATA.

Monoprice carries a full line of quality SAS cables with connectors for every possible application, both internal and external.